Lessons, Recordings, How Tos, Repair, Accessories > Lessons, Recordings, How Tos, Repair, Accessories
Baggs PADI - What do I need to know?
markallen:
I've just purchased a PADI which should arrive int he next couple days. Any good advice on using it with an ES system? Prior to the PADI, I've just been plugging into a small board or directly into a Schertler Unico amp. Not sure exactly what I'm looking for other than some general guidance from this wonderful group so I can reduce the learning curve a bit.
Thanks,
Mark
Herb Hunter:
Is your guitar is Expression System equipped, when plugging into your Unico, what type of cable have you been using and into which input of your amp have you been using?
markallen:
--- Quote from: HLH on December 15, 2011, 08:04:58 AM ---Is your guitar is Expression System equipped, when plugging into your Unico, what type of cable have you been using and into which input of your amp have you been using?
--- End quote ---
Yes, I have the ES on my guitar and I'm presently running TRS/XLR from guitar to Unico and there is a lot of noise.
Edward:
The PADI is a good unit ...I used mine for years until I decided to go to the Venue, which BTW lacks one great feature the PADI has: phantom power. Ugh, no idea why Baggs would drop such a key feature!!
In any event, experiment plugging into your PADI with balanced and unbalanced guitar cables. I used to go all balanced with an in-line matching transformer going into the DI, but after some experimenting, simply found no advantage. Regular guitar cable stright into the PADI was equally quiet (no quieter than dead quiet :) ). Adjust the gain for the differing input signal strength and I got the same great tones and same dynamics, just one less thing to setup/tear down. Food for thought, anyway :)
Edward
Herb Hunter:
--- Quote from: markallen on December 15, 2011, 10:30:40 AM ---
--- Quote from: HLH on December 15, 2011, 08:04:58 AM ---Is your guitar is Expression System equipped, when plugging into your Unico, what type of cable have you been using and into which input of your amp have you been using?
--- End quote ---
Yes, I have the ES on my guitar and I'm presently running TRS/XLR from guitar to Unico and there is a lot of noise.
--- End quote ---
Is the Expression System in your guitar equipped with a fuse? If so, and the fuse is blown, that could account for the noise.
Because the PADI does not have a low-impedance, balanced input. You will likely get the best results plugging the XLR side of your cable into a $20 Radio Shack impedance transformer and then plugging the transformer into the PADI. Then you can connect your PADI to your Unico using the DI output.
Navigation
[0] Message Index
[#] Next page
Go to full version